26 models with a 600 mm bore in this type, with outer diameter and width. Outer diameters on this page run from 700 mm to 870 mm.
| Model | Brand | Type | OD D (mm) | Width B (mm) | |
|---|---|---|---|---|---|
| 76/600D | ANDGE | Angular Contact Ball Bearings | 700 | 100 | — |
| BDA-8002 | SKF | Angular Contact Ball Bearings | 710 | 67 | — |
| 16768/660H | ANDGE | Angular Contact Ball Bearings | 730 | 60 | — |
| 708/600 AGMB | SKF | Angular Contact Ball Bearings | 730 | 42 | — |
| 708/600 AMB | SKF | Angular Contact Ball Bearings | 730 | 42 | — |
| 718/600 AC/VQ074 | SKF | Angular Contact Ball Bearings | 730 | 60 | — |
| 718/600 AMB | SKF | Angular Contact Ball Bearings | 730 | 60 | — |
| 718/600AC | ANDGE | Angular Contact Ball Bearings | 730 | 60 | — |
| 718/600ACF1 | ANDGE | Angular Contact Ball Bearings | 730 | 60 | Cross-ref → |
| 718/600ACM | ANDGE | Angular Contact Ball Bearings | 730 | 60 | — |
| 718/600ACM-CB | ANDGE | Angular Contact Ball Bearings | 730 | 60 | — |
| E11068/600 | ANDGE | Angular Contact Ball Bearings | 730 | 60 | — |
| E16768/660 | ANDGE | Angular Contact Ball Bearings | 730 | 60 | — |
| QJF718/600R | ANDGE | Angular Contact Ball Bearings | 730 | 60 | — |
| S718/600 | ANDGE | Angular Contact Ball Bearings | 730 | 60 | — |
| S718/600C | ANDGE | Angular Contact Ball Bearings | 730 | 60 | — |
| SN 718/600 | ANDGE | Angular Contact Ball Bearings | 730 | 60 | — |
| SN 718/600A/HCP5 | ANDGE | Angular Contact Ball Bearings | 730 | 60 | — |
| SN 718/600C | ANDGE | Angular Contact Ball Bearings | 730 | 60 | — |
| SN718/600 | ANDGE | Angular Contact Ball Bearings | 730 | 60 | — |
| 719/600 ACM | SKF | Angular Contact Ball Bearings | 800 | 90 | — |
| 719/600AC | ANDGE | Angular Contact Ball Bearings | 800 | 90 | — |
| 461/600 | ANDGE | Angular Contact Ball Bearings | 870 | 118 | — |
| 70/600 AGMB | SKF | Angular Contact Ball Bearings | 870 | 118 | — |
| 70/600AC | ANDGE | Angular Contact Ball Bearings | 870 | 118 | — |
| QJF 10/600 | ANDGE | Angular Contact Ball Bearings | 870 | 118 | — |
The bore is the shaft diameter, so it is the one dimension you cannot change: pick the bore first, then decide the type from the load and speed, then the outer diameter from the housing you have. If the housing is fixed, filter by outer diameter in the product center. For fits and shaft tolerances see the fit recommendations.