25 models with a 440 mm bore in this type, with outer diameter and width. Outer diameters on this page run from 600 mm to 800 mm.
| Model | Brand | Type | OD D (mm) | Width B (mm) | |
|---|---|---|---|---|---|
| QJF 1088X1 | ANDGE | Angular Contact Ball Bearings | 94 | — | |
| 71988 ACMB | SKF | Angular Contact Ball Bearings | 600 | 74 | — |
| 71988AC | ANDGE | Angular Contact Ball Bearings | 600 | 74 | — |
| QJ 1988 N2MA | SKF | Angular Contact Ball Bearings | 600 | 74 | — |
| QJ 1988N2MA | ANDGE | Angular Contact Ball Bearings | 600 | 74 | — |
| QJF 1988MB | ANDGE | Angular Contact Ball Bearings | 600 | 74 | — |
| QJ 1088X1 | ANDGE | Angular Contact Ball Bearings | 649.5 | 94 | — |
| 156188/W33 | ANDGE | Angular Contact Ball Bearings | 650 | 188 | — |
| 4088X2D/W33 | ANDGE | Angular Contact Ball Bearings | 650 | 188 | — |
| 7088 AM | SKF | Angular Contact Ball Bearings | 650 | 94 | — |
| 7088 BM | SKF | Angular Contact Ball Bearings | 650 | 94 | — |
| 7088B | ANDGE | Angular Contact Ball Bearings | 650 | 94 | — |
| 7088B/DF | ANDGE | Angular Contact Ball Bearings | 650 | 188 | — |
| 7088BF1 | ANDGE | Angular Contact Ball Bearings | 650 | 94 | Cross-ref → |
| 7088BGM/DF | ANDGE | Angular Contact Ball Bearings | 650 | 188 | Cross-ref → |
| 7088BM/DF/S0 | ANDGE | Angular Contact Ball Bearings | 650 | 188 | — |
| 7088BM/DF/S0/HV2 | ANDGE | Angular Contact Ball Bearings | 650 | 188 | — |
| QJ 1088 | ANDGE | Angular Contact Ball Bearings | 650 | 94 | Cross-ref → |
| QJ 1088 N2MA | SKF | Angular Contact Ball Bearings | 650 | 94 | — |
| QJ 1088N2MA | ANDGE | Angular Contact Ball Bearings | 650 | 94 | — |
| QJF 1088 | ANDGE | Angular Contact Ball Bearings | 650 | 94 | Cross-ref → |
| QJF 1088MB | ANDGE | Angular Contact Ball Bearings | 650 | 94 | — |
| QJ 1288 N2MA | SKF | Angular Contact Ball Bearings | 790 | 155 | — |
| QJ 1288N2MA | ANDGE | Angular Contact Ball Bearings | 790 | 155 | — |
| QJF 1288 | ANDGE | Angular Contact Ball Bearings | 800 | 160 | — |
The bore is the shaft diameter, so it is the one dimension you cannot change: pick the bore first, then decide the type from the load and speed, then the outer diameter from the housing you have. If the housing is fixed, filter by outer diameter in the product center. For fits and shaft tolerances see the fit recommendations.