24 models with a 145 mm bore in this type, with outer diameter and width. Outer diameters on this page run from 153 mm to 225 mm.
| Model | Brand | Type | OD D (mm) | Width B (mm) | |
|---|---|---|---|---|---|
| 145X164X14 CRSA1 R | SKF | Custom & Special Bearings | — | ||
| 145X170X13 CRSA1 R | SKF | Custom & Special Bearings | — | ||
| 145X175X14 CRS1 R | SKF | Custom & Special Bearings | — | ||
| 145X175X15 HMS5 RG | SKF | Custom & Special Bearings | — | ||
| 145X175X15 HMSA10 RG | SKF | Custom & Special Bearings | — | ||
| 145X175X15 HMSA10 V | SKF | Custom & Special Bearings | — | ||
| 145X180X12 HMS5 V | SKF | Custom & Special Bearings | — | ||
| 145X180X12 HMSA10 RG | SKF | Custom & Special Bearings | — | ||
| 145X180X12 HMSA10 V | SKF | Custom & Special Bearings | — | ||
| K145x153x28 | NTN | Custom & Special Bearings | 153 | 28 | — |
| K145x153x36 | NTN | Custom & Special Bearings | 153 | 36 | — |
| RNA4826 | INA | Custom & Special Bearings | 165 | 35 | Cross-ref → |
| AXS145169 | INA | Custom & Special Bearings | 169 | 7.4 | — |
| NK145/32 | NTN | Custom & Special Bearings | 170 | 32 | — |
| NK145/42 | NTN | Custom & Special Bearings | 170 | 42 | — |
| NW1829 | ANDGE | Custom & Special Bearings | 180 | 18 | — |
| 234728BM/SP | ANDGE | Custom & Special Bearings | 210 | 84 | — |
| 234728BM/UP | ANDGE | Custom & Special Bearings | 210 | 84 | — |
| 234728BM1 | ANDGE | Custom & Special Bearings | 210 | 84 | Cross-ref → |
| 234728M1 | ANDGE | Custom & Special Bearings | 210 | 84 | — |
| FC2942155/P6 | ANDGE | Custom & Special Bearings | 210 | 155 | — |
| FC 2944120 | ANDGE | Custom & Special Bearings | 220 | 120 | — |
| 313924 | ANDGE | Custom & Special Bearings | 225 | 156 | — |
| FC2945156M | ANDGE | Custom & Special Bearings | 225 | 156 | — |
The bore is the shaft diameter, so it is the one dimension you cannot change: pick the bore first, then decide the type from the load and speed, then the outer diameter from the housing you have. If the housing is fixed, filter by outer diameter in the product center. For fits and shaft tolerances see the fit recommendations.